Difference between revisions of "MDOS usage"

From Ninerpedia
Jump to navigation Jump to search
 
(One intermediate revision by one other user not shown)
Line 30: Line 30:


Copies the contents of the screen to the printer.
Copies the contents of the screen to the printer.
=== CTRL - C, CTRL - Break ===
Stops program execution (if interrupts are enabled).
=== CTRL - S, CTRL - NumLock ===
Halts screen output.
=== CTRL - P, CTRL - PrtScr ===
Starts / Stops logging mode (output is copied to the printer).


[[Category:Geneve]]
[[Category:Geneve]]
[[Category:Usage]]
[[Category:Usage]]
[[Category:MDOS]]
[[Category:MDOS]]

Latest revision as of 15:48, 9 July 2023

Magic keys

ShiftL and ShiftR are the left and right shift keys.

CTRL - Alt - Del

A well known combination from PC usage, this sequence restarts MDOS without booting. It is equivalent to calling

BLWP @>0000

in a program run in MDOS.

When in the GPL manager, this combination exits the GPL manager and returns to MDOS.

CTRL - ShiftL - ShiftR

With this combination you can cause a reboot of the system, i.e. the memory is cleared and tested, and MDOS is loaded from disk or harddrive. This is basically the same state as after turning the system on.

When in GPL mode (TI-99 simulation), this combination returns control to the GPL manager.

ShiftL - ShiftR - ESC

Launches the debugger if it has been installed; it causes a

BLWP @>FFFC

and is therefore equivalent to the LOAD interrupt which can be externally triggered.

Alt - PrtSc

Copies the contents of the screen to the printer.

CTRL - C, CTRL - Break

Stops program execution (if interrupts are enabled).

CTRL - S, CTRL - NumLock

Halts screen output.

CTRL - P, CTRL - PrtScr

Starts / Stops logging mode (output is copied to the printer).