Difference between revisions of "Open MESS issues"

From Ninerpedia
Jump to navigation Jump to search
 
Line 15: Line 15:
''Symptom'': The Geneve does not boot from disk when the disk is inserted too late. Once the "CANNOT READ FROM FLOPPY DISK" appeared (because there was no disk in the drive), it fails to read the disk on retry.<br/>
''Symptom'': The Geneve does not boot from disk when the disk is inserted too late. Once the "CANNOT READ FROM FLOPPY DISK" appeared (because there was no disk in the drive), it fails to read the disk on retry.<br/>
''Workaround'': Ensure that a boot disk is inserted when starting. Or try to pause the emulation (partial mode, press p), insert the disk, and continue.
''Workaround'': Ensure that a boot disk is inserted when starting. Or try to pause the emulation (partial mode, press p), insert the disk, and continue.
=== Serial output does not work ===
I have not yet managed to write output to the emulated RS232 interface.


=== Geneve joystick ===
=== Geneve joystick ===

Latest revision as of 14:41, 17 October 2011

Back to TI MESS emulation home page.

Crashes

TI-99/8 Extended Basic II with selected floppy controller locks up on start

Symptom: When selecting Extended Basic II, the floppy is accessed, and then the emulator is trapped in an endless loop. This does not occur if no floppy controller is active.
Reason: The TI-99 DSR in Extended Basic II assumes that PABs can also reside in CPU RAM. However, this is not supported by the DSRs in the expansion cards. Accordingly, the PAB is not found, and Extended Basic II does not properly handle this case and crashes.
Workaround: Any other cartridge (like Editor/Assembler) works, so you have no floppy support in Extended Basic II, and this cannot be repaired, since the error is in Extended Basic II. Hexbus devices may be supported, but this is not available in MESS yet.

Failures

Geneve fails to boot from disk

Symptom: The Geneve does not boot from disk when the disk is inserted too late. Once the "CANNOT READ FROM FLOPPY DISK" appeared (because there was no disk in the drive), it fails to read the disk on retry.
Workaround: Ensure that a boot disk is inserted when starting. Or try to pause the emulation (partial mode, press p), insert the disk, and continue.

Geneve joystick

Symptom: Joystick in native mode has been reported not to work. Needs verification.

Keyboard issues with natural keyboard

Symptom: Natural keyboard keyboard sluggish; key repetition interferes with TI key handling